精品国产一区二区-精品国产一区二区三区19-精品国产一区二区三区www-精品国产一区二区三区不卡-精品国产一区二区三区不卡在线

[Mounting Instructions]
!
CAUTION
Use the PLC within the general specifications environment given in this manual.
Using the PLC outside the general specification range environment could lead to electric
shocks, fires, malfunctioning, product damage or deterioration.
While pressing the installation lever located at the bottom of module, insert the module fixing
tab into the fixing hole in the base unit until it stops. Then, securely mount the module with the
fixing hole as a supporting point.
Incorrect loading of the module can cause a malfunction, failure or drop.
When using the module in the environment of much vibration, tighten the module with a screw.
Tighten the screws within the specified torque range.
Undertightening can cause a drop, short circuit or malfunction.
Overtightening can cause a drop, short circuit or malfunction due to damage to the screws or
module.
Completely turn off the externally supplied power used in the system before installing or
removing the module. Not doing so may damage the product.
Do not directly touch the module's conductive parts and electronic components of the module.
Touching the conductive parts and electronic components of the module could cause an
operation failure or give damage to the module.
Make sure that the connectors for the servo amplifier and peripheral devices have been
securely installed until a click is heard.
Not doing so could lead to a poor connection, resulting in erroneous input and output.
When the servo amplifier is not installed, install the connector cover without fail.
Failure to observe this could lead to a malfunction.
差動輸出定位模塊 QD75D4
對應SSCNET定位模塊 QD75M1
對應SSCNET III定位模塊 QD75MH4
定位模塊(升級版) QD75P1N
定位模塊 QD75P4
定位模塊 QD75P1
定位模塊 QD75P1，QD75P2，QD75P4
差動輸出定位模塊(升級版) QD75D1N
定位模塊(升級版) QD75P4N
差動輸出定位模塊(升級版) QD75D2N
定位模塊(升級版) QD75P2N
差動輸出定位模塊(升級版) QD75D4N
差動輸出定位模塊 QD75D1
對應SSCNET III定位模塊 QD75MH1
對應SSCNET III定位模塊 QD75MH2
對應SSCNET定位模塊 QD75M2
定位模塊 QD75P2
差動輸出定位模塊 QD75D2
對應SSCNET定位模塊 QD75M4