精品国产一区二区-精品国产一区二区三区19-精品国产一区二区三区www-精品国产一区二区三区不卡-精品国产一区二区三区不卡在线

1. To prevent electric shock, note the following:
WARNING
Before wiring or inspection, switch power off and wait for more than 10 minutes. Then, confirm the voltage
is safe with voltage tester. Otherwise, you may get an electric shock.
Connect the servo amplifier and servo motor to ground.
Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the servo amplifier and servo motor until they have been installed. Otherwise, you
may get an electric shock.
Operate the switches with dry hand to prevent an electric shock.
The cables should not be damaged, stressed, loaded, or pinched. Otherwise, you may get an electric shock.
2. To prevent fire, note the following:
CAUTION
Do not install the servo amplifier, servo motor and regenerative brake resistor on or near combustibles.
伺服驅動器 MR-J2S-350A4
伺服控制器 MR-J2S-500B4
控制器放大器總線電纜 MR-J2HBUS5M-A
伺服驅動器 MR-J2S-40B
伺服驅動器 MR-J2S-55KA4
伺服控制器 MR-J2S-30KB
接線端子塊電纜 MR-J2TBL05M
伺服控制器 MR-J2S-350B
伺服放大器 MR-J2S-100B4
伺服控制器 MR-J2S-30KA4
控制器放大器總線電纜 MR-J2CN1-A
附件 MR-J2HBUS1M
伺服控制器 MR-J2S-22KA
伺服控制器 MR-J2S-11KB4
伺服控制器 MR-J2S-37KB
伺服驅動器 MR-J2S-40A
伺服驅動器 MR-J2S-10B
伺服驅動器 MR-J2S-45KA4
CON2接頭 MR-J2CMP2
伺服驅動器 MR-J2S-15KB4
伺服驅動器 MR-J2S-60B
伺服驅動器 MR-J2S-100A4
伺服放大器 MR-J2S-200B4
伺服放大器 MR-J2S-70B
伺服放大器 MR-J2S-70A
伺服驅動器 MR-J2S-37KA4
伺服放大器 MR-J2S-100B
接線端子塊電纜 MR-J2TBL1M
伺服控制器 MR-J2S-15KB
CC-Link接口單元 MR-J2S-T01