三菱 手冊 三菱-手冊_MR-J3-T
所屬類別：三菱
>> 伺服驅動器和伺服電機
資料介紹：
4. Additional instructions
The following instructions should also be fully noted. Incorrect handling may cause a fault, injury, electric shock,
etc.
(1) Transportation and installation
CAUTION
Transport the products correctly according to their weights.
Stacking in excess of the specified number of products is not allowed.
Do not carry the servo motor by the cables, shaft or encoder.
Do not hold the front cover to transport the servo amplifier. The servo amplifier may drop.
Install the servo amplifier in a load-bearing place in accordance with the Instruction Manual.
Do not climb or stand on servo equipment. Do not put heavy objects on equipment.
The servo amplifier and servo motor must be installed in the specified direction.
Leave specified clearances between the servo amplifier and control enclosure walls or other equipment.
Do not install or operate the servo amplifier and servo motor which has been damaged or has any parts
missing.
Provide adequate protection to prevent screws and other conductive matter, oil and other combustible
matter from entering the servo amplifier and servo motor.
Do not drop or strike servo amplifier or servo motor. Isolate from all impact loads.
When you keep or use it, please fulfill the following environmental conditions.
Conditions
伺服放大器 MR-J3-60B
伺服放大器 MR-J3-10A
伺服放大器 MR-J3-20B
伺服放大器 MR-J3-700B
伺服放大器 MR-J3-500A
伺服放大器 MR-J3-500B
伺服放大器 MR-J3-40A
伺服放大器 MR-J3-10B
伺服放大器 MR-J3-700A
伺服放大器 MR-J3-70A
伺服放大器 MR-J3-200A
伺服放大器 MR-J3-40B
伺服放大器 MR-J3-350B
伺服放大器 MR-J3-100B
伺服放大器 MR-J3-200B
伺服放大器 MR-J3-70B
伺服放大器 MR-J3-350A
伺服放大器 MR-J3-100A
伺服放大器 MR-J3-20A
伺服放大器 MR-J3-60A
上一條：
下一條：相關下載
