精品国产一区二区-精品国产一区二区三区19-精品国产一区二区三区www-精品国产一区二区三区不卡-精品国产一区二区三区不卡在线

*1. Use the FROM and TO instructions in FX3G PLCs.
Sequence program transfer and data register check
1) Transfer the sequence program, and start the PLC.
2) The 4AD analog data input mode will be stored in data registers (D0 to D3) of the PLC.
3) Check that the data is stored in D0 to D3.
→ If the data is not properly stored, refer to Chapter 8 "Troubleshooting."
M8002
FNC 12
MOV
H**** U…\GO P
M8000
K50 T0
T0
Specify the input mode (BFM #0) for channels
1 to 4.
Initial pulse
FNC 15
BMOV
U…\G10 D0 K4
5 seconds after starting the PLC, the digital
values of channels 1 to 4 (BFM #10 to #13) will
be read out to D0 to D3.
Unit number (step 1)
RUN monitor
PLC FX3G-24MT/ESS
RS-232C擴展板 FX3G-232-BD
模擬量輸入擴展板 FX3G-2AD-BD
擴展板 FX3G-8AV-BD
RS-422擴展板 FX3G-422-BD
擴展板 FX3G-CNV-ADP
PLC FX3G-60MT/ESS
PLC FX3G-14MR/ES-A
PLC FX3G-40MT/ES-A
PLC FX3G-24MT/ES-A
可編程控制器 FX3G系列
RS-485擴展板 FX3G-485-BD
PLC FX3G-60MT/ES-A
PLC FX3G-40MR/ES-A
PLC FX3G-24MR/ES-A
PLC FX3G-40MT/ESS
PLC FX3G-14MT/ES-A
模擬量輸出擴展板 FX3G-1DA-BD
PLC FX3G-14MT/ESS
PLC FX3G-60MR/ES-A