三菱 ID 三菱-ID Interface 模塊 用戶手冊 (硬件)
所屬類別：三菱
>> AJ系列CC-Link模塊
資料介紹：
CAUTION
• Use the PLC in an operating environment that meets the general specifications described in the
manual.
Using the PLC in any other operating environments may cause an electric shock, a fire or a
malfunction, or may damage or degrade the PLC.
• Before installing the module, securely insert the module fastening latch at the lower part of the
module into the installation hole on the base unit. (Q Series modules must be fixed to the base unit
with screws using the specified torque.)
If the module is not installed properly, it may cause the module to malfunction, fail or fall off.
• Tighten the installation screws within the specified torque.
If the screws are loose, it may cause the module to fall off or malfunction.
If the screws are tightened excessively, it may damage the screws and the module, and cause the
module to fall off or malfunction.
• Connect the reader writer cables securely to the connectors of the module. After connecting, make
sure to check that the cables are not loose.
If the cables are loose, poor cable connections may cause erroneous inputs and/or outputs.
• Do not directly touch the conducting parts and electronic parts of the module.
It may cause the module to malfunction or fail.
[WIRING PRECAUTIONS]
CAUTION
• Before starting any installation or wiring work, make sure to shut off all phases of the power supply
模塊 A1SJ71ID2-R4
模塊 AJ35PTC-CNV-GI
外部輸入/輸出單元 GT15-DIOR
適配器 Q6DIN3
模塊 A1SD32ID2
模擬量輸出模塊 Q68DAV，Q68DAI
仿真單元 A6SIM-X64Y64
模塊 A1SD35ID1
中斷輸入模塊 QI60
模塊 AD32ID1
中繼模塊 AJ65BT-RPI-10A
模塊 AJ35PP-CNV-SI
模塊 AJ35PTC-CNV-GI
中斷模塊 AI61
模擬量模塊 AJ65VBTCU-68ADIN
模擬量輸出模塊 A1S68DAI
模擬輸出模塊 A616DAI
模塊 AD32ID2
模擬量輸入模塊 Q68ADV，Q68ADI
模擬量模塊 AJ65BT-64DAI
電流輸出模擬量模塊 Q68DAIN
模擬量輸出模塊 A68DAI-S1
模塊 A1SD32ID1
適配器 Q6DIN1
適配器 Q6DIN2
電流輸入模擬量模塊 Q68ADI
速中斷模塊 A1SI61
轉(zhuǎn)換適配器 FX2NC-CNV-IF
模塊 AD35ID2
模塊 A1SJ71ID1-R4
上一條：
下一條：相關(guān)下載
